EVSE - Stop Write
EVSE - Stop Write — Writes data to the EVSE board
during the Stop state of the charge cycle.
Library
Simulink Real-Time - Speedgoat
Description
The EVSE Stop Write block writes data to the EVSE charging board during the Stop
state of the charge cycle.
Ports
Inputs
-
Stop Progress
Provides the EVSE's information if the charging process shall either
be terminated or paused. Following enumeration table
"chargingSessionType" of ISO15118-2.
-
EVSE Processing
This enumeration signal provides the processing status of the charger,
following the enumeration table "EVSEProcessingType" of ISO 15118-2:
Parameters
Main Tab
-
Station ID
Defines the Station ID of the corresponding Setup block. Must range
between 0 and 65535.
-
Connection ID
Defines the Connection ID of the corresponding Setup block. Must range
between 0 and 65535.
-
Sample Time
Defines the base sample time at which this driver block gets its
sample hit. This parameter can also be set to -1 for inherited sample time. The units are in
seconds.
Enable/Disable Signals Tab
Some settings, like min. and max. voltage limits, are already set by the Setup
block but can be overwritten during the Parameter Discovery state of the charge
if desired. However, unused signals that remain unconnected are set to zero. To
avoid setting parameters to zero, unused signals should be unchecked here to
disable the write operation.
The following signals can be disabled: