Documentation

EVSE Processing

This enumeration signal provides the processing status of the charger, following the enumeration table "EVSEProcessingType" of ISO 15118-2:

• 0: Finished

• 1: Ongoing

• 2: Ongoing, waiting for customer interaction

Isolationstatus

Set the charger's isolation status following enumeration table "isolationLevelType" of ISO 15118-2.

• 0: Invalid

• 1: Valid

• 2: Warning

• 3: Fault

• 4: No isolation monitoring device (IMD) present

Statuscode

Set the charger's status following enumeration table "DC_EVSEStatusCodeType" of ISO 15118-2.

• 0: Not Ready

• 1: Ready

• 2: Shutdown

• 3: Utility interrupt event

• 4: Isolation monitoring active

• 5: Emergency shutdown

• 6: Malfunction

Station ID

Defines the Station ID of the corresponding Setup block. Must range between 0 and 65535.

Connection ID

Defines the Connection ID of the corresponding Setup block. Must range between 0 and 65535.

Sample Time

Defines the base sample time at which this driver block gets its sample hit. This parameter can also be set to -1 for inherited sample time. The units are in seconds.

Some settings, like min. and max. voltage limits, are already set by the Setup block but can be overwritten during the Parameter Discovery state of the charge if desired. However, unused signals that remain unconnected are set to zero. To avoid setting parameters to zero, unused signals should be unchecked here to disable the write operation.

The following signals can be disabled: